- Three-Axis Motorized Gimbal Stabilizer
- Designed for Mirrorless Cameras
- Extended Grip Mini Tripod
- Quick Release Plate with 1/4"-20 Screw
Small and light
The DJI Ronin-SC Gimbal Stabilizer is designed for small mirrorless cameras under 4.4 lb. Although the Ronin-SC is small, it packs an abundance of features, design enhancements, and technology inside its compact form, such as stabilization, pan, tilt, and roll control, as well as 360° continuous panning to create steady 3D/360° motion shots. The gimbal is ultra-portable and due to being low weight, it is easier to hold the gimbal with a mounted camera for longer periods of time.
11 hour battery life
The Ronin-SC is powered by a 2450mAh rechargeable 18650 LiPo battery which is built into its handle and lasts up to 11 hours on a single charge. It is charged via a USB Type-C port and can also provide camera control such as run/stop or focus pulling using one of the included multiport USB cables connected to a compatible camera. There are also 1/4"-20 and 3/8"-16 mounting threads on the handle to add accessories such as a smartphone holder (included).
DJI RSS Splitter
Connect the Ronin-SC focus motor to the gimbal for power and camera control with the included RSS Splitter. This cable features a straight USB Type-C connector to connect to the focus motor port, and the other end features a right-angle USB Type-C connector to connect to the Ronin-SC camera control port. You can connect the centre splitter directly to a compatible camera to enable camera control, using a USB Type-C cable (not included).
DJI Focus Motor
Pull focus while balancing your camera on the Ronin-SC gimbal with the included DJI Focus Motor. Designed specifically for use with the Ronin-SC, the motor features a standard 0.8 MOD gear, a gear belt to affix around your camera lens, and a 12mm rod and rod clamp to mount onto your Ronin-SC.
DJI Focus Motor Rod Mount
Attach the Ronin-SC Focus Motor to your gimbal using the included Focus Motor Rod Mount. The rod clamp attaches to the camera riser plate with the included M4 screws and the 12mm rod clamps into the mount.