You may also like these...
The Rycote Tac!T filter is an in-line, active "third-order" (18dB/octave) filter with a knee at approximately 60Hz. This enables it to pass, unaffected, virtually all of the desired audio, while massively reducing wind noise, handling noise and floor transmitted vibrations. The energy in these extreme low frequency and infrasonic sounds can be very high, and if not attenuated, would otherwise cause overloads and disturbances across the entire audio spectrum.
The Tac!T filter draws its power from the P48 phantom supply while also passing power on to the microphone. It is electronically symmetrical and does not disturb the intrinsic balance of the microphone circuit, nor does it introduce any signal loss for normal programme frequencies.
Tac!T Filter Typical Performance Signal Loss 0dB @ 1kHz,
-3dB @ 63Hz,
-40dB @ 14Hz
Introduced Noise (22Hz -22kHz) - 1.5dB Max signal level +3dBu (<0.2% distortion) Specifacations Cable Length 45cm (18") Cable diameter OD 4.8 mm Connectors Neutrik® XX series, XLRm3* to female XLRf3, Black casing, gold pins Cable Type Ultra flexible Mogami® W2893 star-quad cable
|Model||40cm XLR-3F/3M Cable with TAC!T Filter|